The following information was submitted:
Transactions: INTERNATIONAL JOURNAL of MATHEMATICS AND COMPUTERS IN SIMULATION
Transactions ID Number: 17-110
Full Name: Michal Stanek
Position: Assistant Professor
Age: ON
Sex: Female
Address: Tomas Bata University in Zlin, nam. T.G. Masaryka 5555, 76001 Zlin
Country: CZECH REPUBLIC
Tel: +420576035153
Tel prefix:
Fax:
E-mail address: stanek@ft.utb.cz
Other E-mails:
Title of the Paper: Simulation of Injection Molding Process by Cadmould Rubber
Authors as they appear in the Paper: Michal Stanek, David Manas, Miroslav Manas, Jakub Javorik
Email addresses of all the authors: stanek@ft.utb.cz,dmanas@ft.utb.cz,manas@ft.utb.cz,javorik@ft.utb.cz
Number of paper pages: 8
Abstract: Simulation analyses of plastics injection molding are a tool for increasing the quality of plastic products and tools, equipment used for shortening the time necessary for preparation of new products for the market and hence leading to lowering production costs. The simulation analyses are nowadays commonly used for production of thermoplastic parts. This article stresses on the fact that injection molding of rubber compounds could be from the calculation purposes analysed already in the constructive phase during the preparation of the production to achieve positive assets, till now related only to the thermoplastic parts.
Keywords: Injection molding, Simulation, Compound, Process, Mold
EXTENSION of the file: .pdf
Special (Invited) Session: Simulation of Injection Molding Process
Organizer of the Session: 655-229
How Did you learn about congress:
IP ADDRESS: 93.99.99.10
