The following information was submitted:
Transactions: WSEAS TRANSACTIONS ON APPLIED AND THEORETICAL MECHANICS
Transactions ID Number: 28-776
Full Name: Prasetyo Edi
Position: Senior Lecturer
Age: ON
Sex: Male
Address: Department of Engineering Design & Manufacture, Faculty of Engineering, University of Malaya, 50603 Kuala Lumpur, MALAYSIA
Country: MALAYSIA
Tel: +60379675399
Tel prefix:
Fax: +60379575330
E-mail address: p_edi@um.edu.my
Other E-mails: edi_phd@yahoo.com
Title of the Paper: the design improvement of airfoil for flying wing uav
Authors as they appear in the Paper: Prasetyo Edi, Nukman Yusoff and Aznijar Ahmad Yazid
Email addresses of all the authors: edi_phd@yahoo.com, nukman@um.edu.my, aznijar@um.edu.my
Number of paper pages: 10
Abstract: This paper intends to presents the design improvement of airfoil for flying wing UAV (Unmanned Aerial Vehicle) when the Author works with Universiti Putra Malaysia. The design was performed using XFOIL code (an interactive program for the design and analysis of subsonic isolated airfoils) and the wind tunnel test results for verification. Eppler E334 (thickness to chord ratio, t/c = 11.93%) is used as a based airfoil. The final design was using Eppler E334 with t/c = 13.5%. It was shown from this work that the result from XFOIL is fairly accurate.
Keywords: Airfoil design, Flying wing, Uav (unmanned aerial vehicle), Aerodynamic design
EXTENSION of the file: .pdf
Special (Invited) Session: airfoil design for flying wing uav (unmanned aerial vehicle)
Organizer of the Session: 605-451
How Did you learn about congress:
IP ADDRESS: 202.185.100.175
