The following information was submitted:
Transactions: INTERNATIONAL JOURNAL of COMPUTERS AND COMMUNICATIONS
Transactions ID Number: 19-396
Full Name: Roland Szabo
Position: Engineer
Age: ON
Sex: Male
Address: Vasile Parvan Av., No. 2, Timisoara 300223
Country: ROMANIA
Tel: 403351
Tel prefix: +40 256
Fax: 403295
E-mail address: roland.szabo@etc.upt.ro
Other E-mails:
Title of the Paper: Oscilloscope Control with PC
Authors as they appear in the Paper: Roland Szabó, Aurel Gontean, Ioan Lie, Mircea Bãbãiþã
Email addresses of all the authors: roland.szabo@etc.upt.ro, aurel.gontean@etc.upt.ro, ioan.lie@etc.upt.ro, mircea.babaita@etc.upt.ro
Number of paper pages: 8
Abstract: In this paper two different oscilloscope control methods are presented. The first method is the classic method to send the SCPI commands via RS232 serial interface. The second method is to use the LabVIEW divers. The first oscilloscope is the HAMEG HM407, which has its control program implemented in MATLAB. The second oscilloscope is the NI PXI-5412 with the control program in LabVIEW. The second control program is much faster and mare simple, but with the classic method we can configure more and have a better control over the oscilloscope. The classic method is also general, because it can be controlled any oscilloscopes and equipment, even if they have no driver. In the first method the driver is made, in the second method a driver is used.
Keywords: Communication Equipment, Control Equipment, Driver, Oscilloscope, Protocol, Remote Handling, Serial Port
EXTENSION of the file: .pdf
Special (Invited) Session: Creating an Oscilloscope Driver
Organizer of the Session: 201-320
How Did you learn about congress:
IP ADDRESS: 212.77.163.104
