The following information was submitted:
Transactions: WSEAS TRANSACTIONS ON HEAT AND MASS TRANSFER
Transactions ID Number: 53-368
Full Name: Tchadja Kagnaya
Position: Doctor (Researcher)
Age: ON
Sex: Male
Address: Toulouse University, Institut Clément Ader, Ecole Mines Albi, F-81013 Albi cedex,
Country: FRANCE
Tel:
Tel prefix:
Fax:
E-mail address: tchadja.kagnaya@mines-albi.fr
Other E-mails:
Title of the Paper: Temperature evolution in a WC-6%Co cutting tool during turning machining: experiment and finite element simulations
Authors as they appear in the Paper: T. Kagnaya, M. Lazard, C. Boher, L. Lambert, T. Cutard
Email addresses of all the authors: myriam.lazard@univ-poitiers.fr
Number of paper pages: 10
Abstract: The present paper focuses on thermal numerical simulations and temperature measurements in a cutting tool during the machining process. The experimental studies deal with turning an AISI 1045 steel with cemented carbide insert (WC-%6Co). During machining, transient temperatures are measured at two points in cutting tool using the embedded thermocouple method. Three cutting force components are simultaneously recorded. The thermal numerical simulations are based on the calculation of the heat flux from cutting forces and heat partition coefficient. Results obtained by thermal numerical simulations are in good agreement with experimental ones.
Keywords: turning machining, WC-%6Co, tool/chip contact, temperature, heat transfer
EXTENSION of the file: .pdf
Special (Invited) Session:
Organizer of the Session:
How Did you learn about congress: heat transfer, turning, cutting tool
IP ADDRESS: 195.220.223.244
